Once the epoxy is ready apply it to the edges of the two pieces and align them together.
Can you join two pieces of granite on a countertop.
Seams in granite countertops are glued together using two part epoxy.
A special clamping system known as a seam puller uses a vacuum pump to attach blocks to each half of the countertop.
Clean the area thoroughly with a moist cloth and let it dry.
A seam is the transition line that forms when two granite tops come together.
Use either a clear or colored epoxy to bind the two pieces of slab together.
All purpose construction adhesive glue can be used for granite slab installations although it is generally only used on the bottom layer of the slab to adhere the slab to the plywood decking for the countertop.
Then check the countertop fit from above.
Pick up the poplar.
It is the fastest easiest most efficient way to put two pieces of countertops together.
Put on one miter bolt and tighten it.
When satisfied attach another bolt.
The void between the tops should be filled with epoxy or polyester glue colored with pigment to match your granite tops.
To force the two pieces.
Do this a little bit at a time.
The two sections are then pulled together with lever operated clamps until the glue sets.
If you re installing granite countertops as part of your kitchen remodel there s a good chance you ll need 2 or more pieces of granite due to size and transportation limitations.
It cannot be used to bond two pieces of granite together because it does not cure as hard as the granite and there are also issues with moisture entrapment and the adhesive never drying out.
Place the two countertop pieces you plan to join together into place where you can nail them down.
Since granite countertops are expensive you want to take care when joining seams in order to make them as unnoticeable as possible.
Attach the two pieces together by using the miter bolts and clamping them to the two blocks of wood you fastened to the undersides on step 3.
Position yourself underneath the countertop.
Typically silicone holds the granite slab to the base.
Then use painter s tape to tape off the edge of both pieces of granite to prevent epoxy from getting on the surface of the countertop.
Some installers use silicone so the countertop pieces can move.
I have used drawbolts in the past and they do work well as this is what they are made for.
Slide one piece of the countertop over far enough so you can stick your hand between the two pieces.
Check the fit again.
Be sure to press firmly on the tape to ensure it has adhered to the counter.
Two part epoxy adhesive fills the gaps seams and joints and forms a secure bond that can be difficult to break without damaging the granite.